Support Articles

Buy Flushing solution for your DTG Kiosk here      

Found under the Printer tab, allows you to control how many prints the printer will do before the wiper blade engages to clean the print-head. By default, this is set to 0, meaning it will not wipe after any print. This is the recommended setting.   Removing the wipe blade...

STOP – IF THIS IS A NEW PRINTER INSTALLATION: Download the User Manual and Rip software at Anajet.com/downloads Your printer was shipped with the ink delivery system partially filled with Cleaning Solution to preserve the integrity of the ink delivery system and prevent the print heads from drying out. The...

The dark colored garment printing principles are essentially the same as light garment printing with added procedures. Refer to the basic white garment printing process prior to learning the black garment printing process. This chapter addresses only those features unique to black garment printing. The basic process is as follows:...

You can also control how long the printer will go before the maintenance station engages to seal off the print heads. The default for this setting is two minutes. The maintenance station seals off the print heads when the printer is idle; this keeps air from drying out the ink...

Replace the ink cartridge(s) that show as Very Low or Empty. Once replaced, select Ok to proceed with current operation. If the LCD control panel display still reads NOT FOUND after a new cartridge is installed, it instead of “GOOD”, it may be installed improperly. Pull out the cartridge and...

It is a good practice to clean the Waste Ink Tank every 6 months and replace it once a year. The white waste ink pigment will settle at the bottom of the tank, and reduce the Waste Ink Tanks capacity. To replace or clean the Waste Ink Tank, follow the...

Remove the Waste Ink Drain Tube from the storage area located inside the printer. Find a receptacle to hold the waste ink and place the non-coupler end of the waste ink tube and place it inside. Insert the Waste Ink Drain Tube coupler into the Waste Ink Drain, on the...

Your browser does not support the video tag. Once a graphic is sent to the printer, it will appear in the printer’s control panel under the Jobs Menu and is ready to print. You can select the number of Copies to Print, adjust the Top and Left Offset using the...

Your browser does not support the video tag. Daily Maintenance Check Ink Cartridges Check printer control panel for EMPTY messages, pull out ink cartridges to double ensure you have ink in the cartridges or replace as needed. Shake white cartridges for at least 10 seconds; have the valve facing upward...

Remove everything on the Print Table, and send a short print job from the computer. When the Print Ready LED lights up, press the <PRINT> button. If the Obstruction Sensor is triggered immediately, the Obstruction Sensor may be faulty or the Print Table may be set too high. Try one...