Support ArticlesDTG

Checking cracks inside the Tube (1) Set a T-shirt or a sheet of A3 or regal-sized paper in the center of the Platen. * When you have set a sheet of paper, lower the Platen to the “C” position to prevent the curled edge of paper from touching the Print...

Replacing Control Box When the PCB's inside is replaced, use GTService Tool to readjust firmware controls. Prepare a voltmeter (tester) and a thermometer and refer to the pages concerned.   (1) Remove Power code (2) Remove Operation Panel      Remove 4 Screws at both sides. Unscrew the Print SW...

Click here to Download the Brother GT-541 operation manual Buy ink for your Brother GT-541 and GT-782

  YOU CAN DOWNLOAD THE BROTHER GT-541 Parts list HERE Buy parts for your brother GT-541 and GT-782

Learn how to set up and get going on your Freejet 330 TX garment printer.   Buy ink for your FREEJET 330TX Garment Printer Buy parts and supplies for FREEJET 330TX Garment Printer

Every month you need to check your waste ink tube for dried ink. This is one of the main causes of ink flow issues. The ink in the tube is exposed to air and dries rather quickly. At the end of every month disconnect the tubing and see where it's...

Wow - so many layers, so many ways to clog. at $1200 ea, it's still not as complicated as an iPhone, so why the crazy price? ah, the mystery

2.7 Obstruction Laser Sensor Adjustment Tools Needed o Phillips Screwdriver o Laser Gauge The laser sensor can only be adjusted once the Table Z-axis motor limit flag has been adjusted see section 2.6 Before adjusting the laser you will need to have your printer updated to the latest firmware. To...

(3) Insert the new Ink Cartridge securely (be careful with the direction).     <Note>     Confirm the color of ink. Loading a wrong color of ink causes damage to the Print Heads. If you have installed a wrong color of ink, immediately contact Brother         ...

Troubleshooting GENERAL PROBLEMS   Problem: After you print the image the color looks great, but after you fix it, the print looks dull.   Causes and Solutions: The temperature is set too high on the heat press. Make sure you test the temperature using heat test strips or a heat...

Texjet RIP v7 Software Operation New Worktable (CTRL + N) This command allows opening a new workspace (keeping the current workspace for future use), if open, and beginning a new job. A workspace is an area defined by the user, usually equal to the platen present in the printer, onto...

Driver installation for USB and NETWORK   Do not connect the printer with the USB cable to the computer before installing the Epson 3880 printer driver. Select accordingly to your computer platform the driver installer found in the driver folder of the Installation USB drive. Run the installation as (as...

It is possible to use our chipless cartridges and/or refill bags with expired chipped cartridges on your Anajet Ri3000 and Ri6000.  I’m not going to say it’s the best or least annoying option, but so many of you have told us that you are tired of paying more money, waiting...

Monthly The monthly maintenance has to be performed at least once a month. Some parts have to be observed for their proper operation and cleaned if necessary. 1. The printer must be ON and on Home screen. 2. Use a cross screwdriver to turn on the maintenance gear counterclockwise to...

The user needs to perform a maintenance procedure to keep the machine running reliably. Most common technical problems appear on machines that have not been maintained properly. The garment printer is not a normal ink jet printer. While printing on garments, the printer must print a lot more ink than...

Wear the t-shirt on the platen Press the Check button Turn on the height lever (8) clockwise to adjust the appropriate height When the Red Limit height indicator (4) turns ON, lower the platen by turning counterclockwise  When the red height limit indicator is OFF then the table has the...