VIDEO Wiper blade clean interval on the Anajet Mpower Printer
customer
Found under the Printer tab, allows you to control how many prints the printer will do before the wiper blade engages to clean the print-head. By default, this is set to 0, meaning it will not wipe after any print. This is the recommended setting. Removing the wipe blade...
VIDEO Filling the Ink on your Anajet Mpower Printer
Dean Armando
STOP – IF THIS IS A NEW PRINTER INSTALLATION: Download the User Manual and Rip software at Anajet.com/downloads Your printer was shipped with the ink delivery system partially filled with Cleaning Solution to preserve the integrity of the ink delivery system and prevent the print heads from drying out. The...
Anajet Mpower - Printing on dark garments
customer
The dark colored garment printing principles are essentially the same as light garment printing with added procedures. Refer to the basic white garment printing process prior to learning the black garment printing process. This chapter addresses only those features unique to black garment printing. The basic process is as follows:...
Anajet Mpower - Cap Head Delay
customer
You can also control how long the printer will go before the maintenance station engages to seal off the print heads. The default for this setting is two minutes. The maintenance station seals off the print heads when the printer is idle; this keeps air from drying out the ink...
Replacing ink cartridges on the Anajet Mpower
customer
Replace the ink cartridge(s) that show as Very Low or Empty. Once replaced, select Ok to proceed with current operation. If the LCD control panel display still reads NOT FOUND after a new cartridge is installed, it instead of “GOOD”, it may be installed improperly. Pull out the cartridge and...
Cleaning the waste ink tank on the Anajet Mpower
customer
It is a good practice to clean the Waste Ink Tank every 6 months and replace it once a year. The white waste ink pigment will settle at the bottom of the tank, and reduce the Waste Ink Tanks capacity. To replace or clean the Waste Ink Tank, follow the...
Emptying the ink waste tank on the Anajet Mpower
customer
Remove the Waste Ink Drain Tube from the storage area located inside the printer. Find a receptacle to hold the waste ink and place the non-coupler end of the waste ink tube and place it inside. Insert the Waste Ink Drain Tube coupler into the Waste Ink Drain, on the...