Support ArticlesDTG

M2 DEFAULT SETTINGS: Buy parts for the DTG M2 and M4 Garment Printer Here! 3.5.4 Confirming Default Settings This section gives an overview of the Setup Menu and the M series default settings. There are some critical M series default settings that ensure that the printer operates in accordance with...

Buy parts for the DTG M2 and M4 Garment Printer Here! 7.1 Introduction This chapter provides information on the maintenance mode2. The maintenance mode2 provides the user with functions of displaying and initializing the life counters. It is used in the manufacturing process, adjustment, and maintenance. The maintenance mode2 is...

Buy parts for the DTG M2 and M4 Garment Printer Here! Release carriage from capping station, and slide it over to the middle of print area You will see 2 “sponges” one is the capping station, and the other is the Flush Tray Assembly. (Indicated below 1-A) Remove Flushing Tray...

Buy the Printhead Cable for the DTG M2 and M4 Garment Printer Here! Release carriage from capping station and roll out to the middle of the printer. (Indicated below 1-A) Place a rag under the area you are working on. Just to catch any ink that might be dropped during...

IMAGE ARMOR F-SERIES CONVERSION INSTRUCTIONS AND MAINTENANCE INFORMATION The F-SERIES inks are designed to replace the OEM ink set for the Epson F-2000 Direct To Garment printer. These inks are designed with high performance capabilities, 35 second white ink cure time with as close a match to the original OEM...

Learn how to repair/replace the capping station on the DTG M2 / M4 Garment Printer  

Click here to download the manual to learn more about how to operate the DTG M2 Garment Printer Get parts for the DTG M2 here Buy Ink for the DTG M2 here

The B-SERIES inks are designed as a replacement bags for the Brother GT3 DTG garment printers. These 380cc bags drop into the existing GT3 carts. Find replacement instructions HERE SOON • 35 Second White ink cure time• 380 mL replacement bags• This bag is NOT manufactured by Brother• Bright, vibrant colors• Recommended...

Learn how to replace the ink cartridge system and damper assembly in your DTG Viper 2 garment printer.  Buy the ink cartridge system and damper assembly for the DTG Viper 2 here      

You can buy an Anajet Sprint Motherboard PCB Replacement here Introduction This is a troubleshooting guide on how to replace a Print engine board (PCB). Scope This applies to FP-125/Sprint printers only. Symptoms Printer is looping in Auto System Maintenance. Printer stuck in reset service counter (only in more severe cases)...

Learn how to replace the belt on the conveyer belt for the DTG Viper Garment Printer Printing Bed Buy the PF BELT for your DTG Viper here  

Learn how to load nk on your FreeJet 320 330TX.  You can buy ink for your FreeJet here and parts here