Support ArticlesDTG

Diagnosis: When printing, the Wait Light turns on and does not turn off.Solution: There are two things that can cause this type of problem. The first one is the most commonand should be tried first but if this does not correct the problem then try second step.  1) If wait...

Get a Replacement print head for your Anajet FP-125 to repair your Anajet sprint Caution: The Print head is very static sensitive, use antistatic protective equiment when working on it.  Before beginning this repair make sure the power is turned off at the back switch and the printer’s power cord...

Get a Replacement print head for your Anajet FP-125 to repair your Anajet sprint Caution: The Print head is very static sensitive, use antistatic protective equiment when working on it. 1 - Remove the Dampers. To avoid ink leaking, place dampers and tubes higher than the level of the ink...

Buy the Anajet Pump and Capping Station Watch a video on Removing the Anajet Sprint Pump and Capping Station Watch a Video on Installing the Anajet Sprint Pump and Capping Station Removing the Control Panel The LCD is very static sensitive, use antistatic protective equipment. Remove the two Phillips (+)...

DTG Kiosk II Training Understanding the Parts and Components1 DTG Kiosk II Training Understanding the Parts and Components 2

DTG Kiosk II Training Non-Textile printing

DTG Kiosk II Training Curing your garments

DTG Kiosk II Training Printing good white ink prints

DTG Kiosk II Training doing a Nozzle check

DTG Kiosk Removing the Wiper for Cleaning

DTG Kiosk changing the mother board

VIDEO DTG Kiosk Installing the Print Head Epson 2200

VIDEO DTG KIOSK Removing the Print Head Epson 2200

DTG Kiosk cleaning the encoder strip

DTG Kiosk Leveling the Tray Bed Part 1   DTG Kiosk Leveling the Tray Bed Part 2

DTG Kiosk Converting ink harness to K2 setup part 1   DTG Kiosk Converting ink harness to K2 setup part 2