Support ArticlesDTG

Learn how to replace the dampers on your neoflex garment printer. You can buy Dampers for your Neoflex Garment Printer Here

Learn how to replace the pump and capping station (maintenance station) on the Veloci-Jet XLYou can buy a pump and capping station for your Veloci-Jet Garment Printer Here  

Watch this video to learn How to replace print head in Veloci Jet XL DTG printer. You can buy a Veloci Jet XL print head here        

Introduction This is a troubleshooting guide on how to resolve issues with air or gaps in the lines of the ink tubes cause banding, color drop out and bad nozzle checks. Scope This applies to mPower printers only. Symptoms • Color drops out and comes back• Visible gaps in ink...

Error Codes (Maintenance)0002 Carriage Motor / Ink Tube end of life (Clear Carriage Motor Counter)0004 Nozzle check error0008 RTC error (Real Time Clock) (Check the Battery and reset the Date and Time)0010 Multi Sensor Error0020 Print Head life counter (Reset the Head counter)0040 Cleaner Unit end of life (Clear the Cleaner counter)0080 Date...

There have been many people who have had problems with their Anajet Sprint going into an auto maintenance loop and locking up.  Through the forums I have seen many fixes or things to try offered.  The items below have been confirmed to help if not fix this problem.  If this...

1) Remove Encoder Strip. Release spring on left side of printer (see Figure 1) ,then remove Encoder Strip from tab on right side of machine. Use two piecesof tape to secure metal tabs on the left end of the rails to the frame of themachine. 2) Move the wiper blade...

Epson R1900 Anajet Exploded Diagram Schematic

Waste ink is collected in the Waste Ink Tank located inside the printer below the Maintenance Station. When the Waste Ink Tank is full the printer will beep once and the LCD control panel will display the message WASTE INK FULL / PLEASE DRAIN. The Waste Ink Tank must be...

Diagnosis: When printing, the print appears correct on one side and fuzzy on another side or corner. Solution: You will need a level to make sure that all four corners of the Print Table are the samedistance from the Carriage Bar. To measure this, place your Gauge Block on the...

If when sending a print job to the printer, and before pressing the Print Button, the Control Panel LCDreads “DO NOT TURN OFF” (Fig. 1) and does not go away within a few minutes and appears to be frozen,this is the result of a scheduled Auto Maintenance attempting to initialize...

Ink may stop flowing in one or more lines for any of four reasons: (Note that a stoppage of ink flow is different from a restriction of ink flow. By “stoppage” this article means that Cleaning Solution cannot be drawn down one or more ink lines, not just that flow...

If when starting up the printer and pressing the Power Button the Control Panel reads “PLEASE WAITSYSTEM INITIALIZING” (Fig. 1)and does not go away within 5 minutes and appears to be frozen, thismeans that you have jobs in the print queue that need to be deleted before the printer can...

There are two ways to classify air in the Ink Tubes.The first scenario is air bubbles in the Tubes. If you have tiny air bubbles in the Tubes you can ignorethem. These bubbles will be smaller than the diameter of the Ink Tubes; they will not cause a problem.These tiny...

  Background: The Reset Service Counter message is a result of the Epson F-mach Print Head used in the AnaJet. Because the Print Head is used in several different types of printers, it tries to keep track of its usage. When the Print Head gets past a certain internal limit,...