Support ArticlesDTG

There are many different ways to set up the color going from your ink bay to your print head. Above you will see the tab where you change it in your program. However, in that program gives you an idea of the different configurations. Best option is the way the...

Click here to download the procedure for fitting the Gap Sensor

Transporting or Storing Your Printer It is extremely important you observe the following before transporting or an extended shutdown of your DTG Kiosk. Preparing the Printer for Transportation If the printer is to be transported over a long distance, and/or by a common carrier (where you cannot control the "care"...

To learn how to install WIMS to Kiosk, click here.  KIOSK PARTS HM1 PARTS INK  

What I normally do is to try to isolate the issue from several possibilities to one. The only way to do that is to swap the cartridges. Follow these instructions to see if it is the damper or the print-head. (1) Perform a nozzle check, and note the bad nozzle...

Download the DTG M2 Service Manual here.

kiWhat I normally do is to try to isolate the issue from several possibilities to one. The only way to do that is to swap dampers. Follow these instructions to see if it is the damper or the print-head. Perform a nozzle check, and note the bad nozzle check and...

Download the Kiosk II Operation Manual

KIOSK PARTS  

Download the DTG Quick Set Up Guide Also, try downloading the DTG Kiosk BASICS Manual Start to Finish List of Setting Up Your DTG Kiosk (1) Inspect carton for damages. (2) Open carton. (3) Remove top cardboard and set aside. DO ONT DISCARD ANY PACKING MATERIALS (4) Inspect to make...

If you bought a used Anajet Sprint, Anajet FP-125 or Melco Jet, it may have come with old, outdated software. It also might not work after install on your computer because it actually needs a EKPrint Studio License Transfer. Who woulda thunk..... You will need to contact http://www.eukondigital.com/transfer The upgrade...

The 1001D error is normally generated on an Epson 4880 printer because the carriage motor is reporting an incorrect voltage being applied to the motor. There are several instances that can cause this. If the print head carriage assembly is obstructed in some way (problem with capping assembly possibly) it...

Get the Epson F2000 F2100 print head cleaning kit 

Get the Epson F2000 F2100 print head cleaning kit 

Removing the Rear Cover (1) With the power on, eject the platen so it not partially in the rear cover. (2) Power off the machine and remove the power cord from the back of the printer. (3) Use a long Phillips Screwdriver to remove teh single Phillips screw on the...

This procedure is used as a possible remedy for misalignment issues with the CMYK ink not covering the white ink properly. A CR Origin Set may have to be performed if the results of this test are not satisfactory. If the printer was moved, even rolled across the room, the CR...