Support ArticlesDTG

Learn how to remove and insert the wiper blade on the maintenance station of a Brother GT direct-to-garment DTG printer. 6-1-5. Replacing the Wiper Blade The Wiper Blade needs to be replaced if it starts to come off to solve the ink-jetting problem. Use the Wiper ASSY (SA9001001) for the...

Learn how to use the garment alignment tool for the Brother GT-541 and GT-782 printers.

Learn how to install the Brother GT-541 or GT-782 Garment Alignment Tool.

Learn how to install the Brother GT direct-to-garment print head into Brother GT-541/GT-782 printers and remove it

Learn how to perform the white ink retrieval procedure for the Brother GT-782 direct-to-garment printer.   The white ink retrieval procedure allows the operator to drain the white ink lines back into the white ink cartridges in order to agitate them to prevent the settling of the white ink pigments....

Learn how to perform the tube clean procedure for the Brother GT-782 direct-to-garment printer. This procedure allows the operator to thoroughly clean the white ink lines to prevent excess build up around the interior of the ink lines. The approximate time for completing this procedure is 10-15 minutes and is...

Over the past several months we have been testing the Image Armor ULTRA with Brother’s white OEM ink. We wanted to present our findings with the industry. In the past, we really did not effectively endorse using our Image Armor ULTRA dark shirt pretreatment with Brother OEM inks. However, in our...

All training videos for the older C engine M2’s are located at the below Youtube Playlist. These videos are not applicable for the new X engine M2 printers. To identify which printer you have, turn the printer on and look for the message “Paper End” or “Cover Open” on the...

Learn different ways to pretreat your garment for Dark shirt printing on the DTG M2.  Pretreating by hand is not easy, it is reccomended to Buy Automatic Pretreatment Machines for the DTG M2 Garment Printer Here!

 Learn how to install the DTG M2 print head on your DTG M2 and M4 Garment Printer.  If you need a print head Buy a Print head for the DTG M2 Garment Printer Here!

Note - No tools are required for this procedure. Use protective gloves to avoid stained fingers. The microfiber cloth (from maintenance kit) will be required for this process. The Encoder Strip is the thin plastic strip that runs behind the Print Head for the length of the carriage area. It looks to...

Learn how to properly flush your DTG M2 and M4 Garment Printer.  Keeping it clean for storage or while on vacation is super important.  If the printer is to be left idle for a long period of time (1 – 2 weeks), then you should flush the system with flushing...

 Understanding maintenance on an y garment printer is important, learn how to maintain and clean your DTG M2 and M4 Garment printer.  If you need cleaning solution Buy Cleaning Soultion for the DTG M2 Garment Printer Here!

 Printing on white shirts is easy with the DTG M2 and M4 Garment printer.  Using the right CMYK is crucial, Buy a Full Liter CMYK Set SPECIAL for the DTG M2 Garment Printer Here!

Printing on dark shirts with any garment printer can be a challenge, however having the right ink makes is much easier.  If you need DuPont ink Buy White Ink for the DTG M2 Garment Printer Here!  

The RIP for the DTG M2 is different than what they use to sell for the DTG HM1 and VIPER, but you can still Buy the RIP Programs for older DTG's Garment Printer Here!