Support ArticlesMelco

EMC 10: Needle Bar Will Not Come Down to Sew If the take-up lever is moving normally but the needle bar will not descend to begin sewing, there are several components on the Melco EMC 10 that should be inspected. Check the Jump Stitch Lever The first item to inspect...

EMC 10: Not at Head Up Error The Not at Head Up Error occurs when the Melco EMC 10 is unable to verify that the sewing head has reached its proper home position. Common Causes One of the most common causes is the needle case being out of position or...

EMC 10: Off Color Index Error The Off Color Index Error indicates that the needle case is not properly aligned with the machine's color indexing system. When this occurs, the EMC 10 may be unable to accurately identify the selected needle position. Check the Color Change LED Locate the Red...

EMC 10: Picker Doesn't Pick Up the Thread If the picker is not properly picking up the thread after a trim, you may experience short tails, no tails, or excessively long thread tails. These issues can lead to thread breaks, poor starts, and inconsistent embroidery quality. What Does the Picker...

EMC 10: Picker Stays In After a Trim If the picker remains engaged after a trim cycle, the machine may experience thread handling issues that can lead to thread wraps, trimming problems, or a Z Time Out Error. Inspect the Picker for Burrs The first item to check is the...

EMC 10: Rack Limit Error A Rack Limit Error occurs when the design extends beyond the available sewing field or when the machine detects that the pantograph is approaching its travel limits. Check the Hoop Selection Before loading and sewing a design, verify that the correct hoop size is selected...

EMC 10: Cap Frame Popping Off During Sewing If the cap frame repeatedly pops off the cap frame driver, or if your design becomes flattened near the edge of the sewing field, the issue is usually related to cap frame alignment, cable tension, component wear, or interference between the cap...

EMC 10: Looping and Bird Nesting Looping and bird nesting are common embroidery issues that can lead to poor stitch quality, thread breaks, and machine stoppages. On the Melco EMC 10, these problems are often related to thread tension, needle selection, design density, or hook assembly components. Check Thread Tension...

EMC 10: Grabber Not Home Error The Grabber Not Home error occurs when the EMC 10 detects that the grabber mechanism has not returned to its home position after a trim cycle. This can be caused by thread remaining in the trimmer system, mechanical binding, alignment issues, or motor-related problems....

To identify the type of machine, it has 4 black sewing heads with six needles each. The serial number will start with 897_ _ _ _. THE MACHINE WON'T COME ON. THE DISPLAY IS BLANK: Check the power source. Make sure it is a working outlet. Make sure it's plugged...

EMC 10: Application Run Error The Application Run Error typically occurs when the Melco EMC 10 is unable to successfully download or load the required RSA files during startup or communication with the control system. This error is commonly related to machine configuration, communication problems, corrupted files, or hardware issues...

EMC 10: Bad CC Encoder Error The Bad CC Encoder error indicates that the EMC 10 is unable to properly communicate with or receive position information from the Color Change (CC) system. This can be caused by configuration issues, wiring problems, a faulty Color Change Board, or a problem with...

CAP FRAME IN: This error will appear on the display if trying to set home with the Cap Frame Driver installed. If the Cap Frame Driver is not installed, then the contact or switch on the mount that indicates the driver is installed is defective or bent so it isn't...